Eaton Leonard produces tube bending machines.

Different control types for Eaton Leonard:

• See Lightspeed controls
• See Premier controls
• See EL-2000 controls
• See VELOG controls

Our VTube-LASER software can communicate with all four bender types above. The Lightspeed requires a network connection. The other three require our Benderlink Ethernet Module electronics. (VTube-LASER uses a FARO arm to measure tube shapes.)

Most of our Benderlink packages are compatible with the Vector Tube Data Center. Our Benderlink Ethernet Module is also compatible with the Vector.

VTube-LASER can communicate with legacy Eaton Leonard benders through current loop electronics (see Benderlink Ethernet Module.

VTube-LASER will allow for the complete setup of all bender and setup data that can be stored in a Premier, EL2000, or Velog control.

The Eaton Leonard values are never lost because this data is now stored inside each VTube-LASER project file.

Press the new "Additional Bender Data" button at the top of the Bender Setup screen, and VTube will now load the new Eaton Leonard Setup window shown (see the second image).

YBC Velocity, Function, Stop, and C Last Included

This data includes all the part setup data and all the data that is included in each YBC row, including these data columns:

• Y
• Y Velocity
• Y Function
• Y Stop
• B
• B Velocity
• B Function
• B Stop
• C
• C Velocity
• C Function
• C Stop
• C Last

Click on the image on the right so see a close-up of this screen.

YBC Data Automatically Synchronized with Blue Column LRA Data in the Parent Window

The YBC data in this Eaton Leonard Setup window is always synchronized with the blue columns in the parent VTube Bender Setup window.

Change the data in either window, and the corresponding data in the other window will automatically change.

Use Either Inches or Millimeters

The screen allows you to switch between Inches and Millimeters and back again with the press of a single button.

• See Eaton Leonard