Difference between revisions of "CNC Bender v15.1"
From ATTWiki
(→25px NEW: Tube Support 2 Added) |
(→25px NEW: Tube Support 2 Added) |
||
| Line 36: | Line 36: | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
| + | |||
| + | <table width=1000> | ||
| + | <tr> | ||
| + | <td width=300> | ||
| + | New options are included in the Low Level Options list to setup the inputs/outputs and commands for Tube Support 2. | ||
| + | |||
| + | </td> | ||
| + | <td width=600> | ||
| + | [[image:cncbender tube support low level options.png|600px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
==Other Pages== | ==Other Pages== | ||
Revision as of 02:31, 27 February 2017
v15.1 - February 25, 2017
|
|
NEW: Tube Support 2 Added
|
We added to CNC Processor the ability to raise and lower a second Tube Support for Feed axis motion on extra long benders. There are now three supports that can be active at the same time:
|
|
|
New options are included in the Low Level Options list to setup the inputs/outputs and commands for Tube Support 2. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
