Difference between revisions of "VTube-LASER v2.8.3"
From ATTWiki
(→25px NEW: Addata ZModem Communications Protocol) |
(→25px NEW: Addata ZModem Communications Protocol) |
||
| Line 36: | Line 36: | ||
[[image:vtube-laser v2.8.3 Addata ZModem Send.png|600px]]<br><br> | [[image:vtube-laser v2.8.3 Addata ZModem Send.png|600px]]<br><br> | ||
| + | </tr> | ||
| + | </table> | ||
| + | <br><br> | ||
| + | |||
| + | |||
| + | <table cellpadding=10 width=900> | ||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | This protocol allows you to setup the COM port configuration to match the configuration at the other end of the serial port connection. Set the protocol to Addata ZModem, then click on the COM port cell to display this COM port configuration dialog. | ||
| + | <td> | ||
| + | </td> | ||
| + | <td> | ||
[[image:vtube-laser_v2.8.3_AddataZModem_Benderlink_ComSetup.png|600px]] | [[image:vtube-laser_v2.8.3_AddataZModem_Benderlink_ComSetup.png|600px]] | ||
</tr> | </tr> | ||
Revision as of 19:12, 24 May 2017
|
Revision 2.8.3Original Release Date: Not Yet Released
|
|
Contents |
NEW: Addata ZModem Communications Protocol
|
We've added an Addata ZModem communications protocol also known as the Addison "Non-Standard Device Interface". |
|
|
This protocol allows you to setup the COM port configuration to match the configuration at the other end of the serial port connection. Set the protocol to Addata ZModem, then click on the COM port cell to display this COM port configuration dialog. |
|
ENHANCED: NUMALLIANCE BENDER OUTPUT
OUTPUTS 180-DEGREE BENDS
OUTPUTS SPRINGBACK-COMPENSATED DATA
|
|
OTHER CHANGES
|
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
