Difference between revisions of "Benderlink Module - Laservision to Crown"
From ATTWiki
| Line 13: | Line 13: | ||
[[image:cb-el1_render1.jpg|right|250px]] | [[image:cb-el1_render1.jpg|right|250px]] | ||
Advanced Tubular uses a special board designed to allow communications with Eaton Leonard Laservisions and benders. See [[Communications Board for Eaton Leonard - CB-EL1]] for detailed information on our electronics. | Advanced Tubular uses a special board designed to allow communications with Eaton Leonard Laservisions and benders. See [[Communications Board for Eaton Leonard - CB-EL1]] for detailed information on our electronics. | ||
| + | |||
| + | |||
| + | ===See Also=== | ||
| + | |||
| + | This module works with [[Benderlink for Crown]] software. | ||
Revision as of 21:53, 31 August 2007
This version of the Benderlink Module connects Eaton Leonard Laservision legacy electronics (commonly called "current loop") to a Crown Unlimited bender.
This model was designed to connect two Laservision measuring centers to one Crown bender. The two Amphenol circular ports use the Eaton Leonard communications cable standard. The ports are switched using an industrial AB switch embedded into the Benderlink module.
CB-EL1 Electronics Board
Advanced Tubular uses a special board designed to allow communications with Eaton Leonard Laservisions and benders. See Communications Board for Eaton Leonard - CB-EL1 for detailed information on our electronics.
See Also
This module works with Benderlink for Crown software.
