Difference between revisions of "How to Scan a Point Cloud"
From ATTWiki
(→Scan) |
(→Scan) |
||
| Line 47: | Line 47: | ||
<br><br> | <br><br> | ||
| + | This image shows six buckets of points - which means we scanned 6 groups of points and pressed the accept button 6 times.<br><br> | ||
[[image:vtl_v2.9.18_pointcloud_scanthenpressaccept.png|600px]] | [[image:vtl_v2.9.18_pointcloud_scanthenpressaccept.png|600px]] | ||
<br><br> | <br><br> | ||
Revision as of 15:16, 7 February 2019
|
|
|
Contents |
Start the Command to Scan
- 1 - Press Measure Process in the Navigation Pane.
- 2 - Press Point Cloud Scanning.
- 3 - Press Scan a New Point Cloud.
Set Diameter Cut Plane OFF if ON
- 4 - Turn Diameter Cut Plane OFF if the maximum cloud radius is zero.
VTube-LASER will display this step if DCP Auto is on and the diameter is set to zero.
Note that you can leave DCP on, but remember that it will limit your laser line length on the tails of the laser.
Scan
- 5 - Scan with the scan button, then press the accept button when have the first bucket of points completed.
This image shows six buckets of points - which means we scanned 6 groups of points and pressed the accept button 6 times.
