Difference between revisions of "Change the default linear units in VTube"
From ATTWiki
| (12 intermediate revisions by one user not shown) | |||
| Line 4: | Line 4: | ||
[[image:vtube-step_logo.jpg|200px]]<br> | [[image:vtube-step_logo.jpg|200px]]<br> | ||
[[image:vtube-laser_logo.jpg|200px]] | [[image:vtube-laser_logo.jpg|200px]] | ||
| − | |||
* Back to [[VTube-STEP]] | * Back to [[VTube-STEP]] | ||
* Back to [[VTube-LASER]] | * Back to [[VTube-LASER]] | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
| − | [[image:Vtube- | + | [[image:Vtube-step_1_651.jpg|300px]]<br> |
| + | [[image:vtube-laser_screen_1_541.jpg|300px]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
| Line 25: | Line 25: | ||
Use the toolbar buttons to clear VTube and press the Linear Units button until the correct units are active.</td> | Use the toolbar buttons to clear VTube and press the Linear Units button until the correct units are active.</td> | ||
<td> | <td> | ||
| − | [[image:vtube- | + | [[image:vtube-step_toolbar_clear_units1.jpg|600px]] |
</td> | </td> | ||
</tr> | </tr> | ||
| Line 32: | Line 32: | ||
Press the System Options button.</td> | Press the System Options button.</td> | ||
<td> | <td> | ||
| − | [[image:vtube- | + | [[image:vtube-step_toolbar_sys1.jpg|400px]] |
</td> | </td> | ||
</tr> | </tr> | ||
| + | <tr> | ||
| + | <td width=300> | ||
| + | Press the Project Setup tab, and then press the Set Project Default State button.</td> | ||
| + | <td> | ||
| + | [[image:vtube-step_setprojdefaultstate1.jpg|400px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | <tr> | ||
| + | <td width=300> | ||
| + | Exit the System Options menu. VTube will now clear to the new linear unit. | ||
| + | </td> | ||
| + | <td> | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
</table> | </table> | ||
<br> | <br> | ||
| Line 40: | Line 56: | ||
==Other Pages== | ==Other Pages== | ||
| − | *Back to the [[VTube]] page | + | *Back to the [[VTube-STEP]] page |
| + | *Back to the [[VTube-LASER]] page | ||
Latest revision as of 14:23, 25 May 2022
|
|
|
Steps to changing the default linear units
| Use the toolbar buttons to clear VTube and press the Linear Units button until the correct units are active. |
|
| Press the System Options button. |
|
| Press the Project Setup tab, and then press the Set Project Default State button. |
|
|
Exit the System Options menu. VTube will now clear to the new linear unit. |
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
