Difference between revisions of "Chiyoda Communications with VTube"

Revision as of 16:58, 2 June 2022

The files used are .CHS files.

STEP 1 Create a template in the Chiyoda with the number of bends the new part will have.
STEP 2 Save the template created on the Chiyoda onto a thumb drive.
STEP 3 Load in the desired part into VTube-STEP (must match the bend count on the template created in the bender)
STEP 4 In VTube-STEP under the Import/Export tab > Export > load Chiyoda Ex File - CHS

STEP 1 Press the System Options button.
STEP 2 Press the RESTORE and Reset VTube Configuration from a VTube Zip Backup File.
STEP 3 Find and open the backup file.
STEP 5 Press Continue in the warning dialog.
STEP 6 Press OK.

@@ Line 17: / Line 17: @@
 The files used are .CHS files. <br><br>
-== Steps to BACKUP the Current Configuration==
+== Steps to send files between the Chyioda and VTube-STEP==
 <table>
@@ Line 34: / Line 34: @@
 ===STEP 2===
-Press the Project Setup tab, and then press the BACKUP VTube Configuration to Zip Backup File button.
+Save the template created on the Chiyoda onto a thumb drive.
 </td>
 <td>
@@ Line 45: / Line 45: @@
 ===STEP 3===
-Use the Save dialog to save a configuration backup.
+Load in the desired part into VTube-STEP (must match the bend count on the template created in the bender)
 </td>
 <td>
@@ Line 56: / Line 56: @@
 ===STEP 4===
-VTube will display a dialog with the configuration file that it saved.  This file is required for complete configuration of VTube - so you can use it to restore a configuration.
+In VTube-STEP under the Import/Export tab > Export > load Chiyoda Ex File - CHS
 </td>
 <td>