Difference between revisions of "CNC Bender v10-20071003"
| Line 10: | Line 10: | ||
===[[image:Check.jpg|25px]] Automatic Cross Check for Module Configuration Files=== | ===[[image:Check.jpg|25px]] Automatic Cross Check for Module Configuration Files=== | ||
| − | CNC Bender can get confused if the module configuration files | + | CNC Bender can get confused if the module configuration files are setup improperly. CNC Bender now performs a module configuration cross check diagnostic every time it starts. |
[[image:Cncbender_moduleconfigfileswarning.jpg|400px]] | [[image:Cncbender_moduleconfigfileswarning.jpg|400px]] | ||
Revision as of 22:43, 3 October 2007
Contents |
CHANGES to CNC BENDER
Automatic Cross Check for Module Configuration Files
CNC Bender can get confused if the module configuration files are setup improperly. CNC Bender now performs a module configuration cross check diagnostic every time it starts.
Update to File Load User Window
The File Load menu User Interface adjusted slightly in order to be more consistent with other CNC Bender menus.
Changed from:
to
CHANGES to CNC PROCESSOR
CNC Processor is the program that directly controls the bender actuators.
Disallow Jog Queuing When in Cycle Hold Mode
CNC Bender no longer allows an operator to jog any axis or actuator if the Cycle Hold button is pressed. This mode is slightly different than SAFE MODE CYCLE HOLD, where the safety scanner area is entered.
How to UPGRADE
If your operator station contains one of the versions listed below, then they can be upgraded through simple self-installation:
- CNC Bender v10-20070920
- CNC Bender v10-20070726b
- CNC Bender v10-20070803
- CNC Bender v10-20070828
- CNC Bender v10-20070914
Please contact Advanced Tubular Technologies for upgrade information.
