Difference between revisions of "Why VTube-LASER Reduces Data to Centerlines"
(→Answer) |
|||
| Line 3: | Line 3: | ||
<td width=200> | <td width=200> | ||
* Why does VTube-LASER reduce data to centerlines?<br><br> | * Why does VTube-LASER reduce data to centerlines?<br><br> | ||
| + | |||
| + | * Back to [[VTube-LASER]] | ||
| + | * Back to [[VTube-STEP]] | ||
| + | |||
</td> | </td> | ||
<td width=200> | <td width=200> | ||
| Line 9: | Line 13: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
==Answer== | ==Answer== | ||
Latest revision as of 15:57, 21 June 2022
|
|
Answer
VTube-LASER always automatically reduces each straight scanned to a centerline and then compares measured centerline data with the master. This has been the method used in the tube-fabrication industry for decades because fabricated tube shapes are always defined using centerline geometry. So, the goal of VTube-LASER is to always reduce a measured profile, whether it be cylinder or rectangular, to a centerline for qualification and bender data calculation.
Before it reduces the straight to a centerline, VTube-LASER always calculates important metrics that help the user gauge how well the surface data fits to the centerline. Not only does it qualify each cylinder straight fit to a centerline, but the process always gives a calculated diameter and the surface profile of the scan.
- See also VTube-LASER Wobble Deviation
- See also VTube-LASER Cylinder Fit Tolerances
