Difference between revisions of "Inspection Tolerances"
From ATTWiki
(Created page with "<table> <tr cellpadding=10> <td width=225> 200px 200px * Back to VTube-STEP * Back to [[VTube-LASER]...") |
|||
| Line 6: | Line 6: | ||
* Back to [[VTube-STEP]] | * Back to [[VTube-STEP]] | ||
* Back to [[VTube-LASER]] | * Back to [[VTube-LASER]] | ||
| − | |||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
| Line 18: | Line 17: | ||
| − | == | + | ==Radial Tolerance== |
| + | |||
| + | |||
<table> | <table> | ||
| Line 33: | Line 34: | ||
<td width=300> | <td width=300> | ||
| − | == | + | ==Linear Tolerance== |
'''Change the values in VTube to whatever you want them be when you perform a project clear in the future.'''<br><br> Be sure that no tube data exits in this state, or VTube will clear the data to preset values with a tube. (Of course, you can do this, if you really intend to do it.)</td> | '''Change the values in VTube to whatever you want them be when you perform a project clear in the future.'''<br><br> Be sure that no tube data exits in this state, or VTube will clear the data to preset values with a tube. (Of course, you can do this, if you really intend to do it.)</td> | ||
<td> | <td> | ||
| Line 42: | Line 43: | ||
<td width=300> | <td width=300> | ||
| − | == | + | ==Angular Toleracne== |
Press the System Options button.</td> | Press the System Options button.</td> | ||
<td> | <td> | ||
| Line 51: | Line 52: | ||
<td width=300> | <td width=300> | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
</table> | </table> | ||
| Line 74: | Line 58: | ||
==Other Pages== | ==Other Pages== | ||
| − | |||
* Back to the [[VTube-STEP]] page | * Back to the [[VTube-STEP]] page | ||
* Back to the [[VTube-LASER]] page | * Back to the [[VTube-LASER]] page | ||
Revision as of 14:00, 20 July 2022
|
|
|
Radial Tolerance
STEP 1Use the toolbar button to clear VTube. |
|
Linear ToleranceChange the values in VTube to whatever you want them be when you perform a project clear in the future.Be sure that no tube data exits in this state, or VTube will clear the data to preset values with a tube. (Of course, you can do this, if you really intend to do it.) |
|
Angular ToleracnePress the System Options button. |
|
|
|
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
