Information about HEXAGON Absolute Arm Hardware

• Back to VTube-LASER

The newer ROMER scanners communicate with the computer using:

1. A TCP/IP connection using an Ethernet cable is used to give feedback from the SCANNER.
   
   
2. A power cable
   
   

You will need one open Ethernet port and one open USB port for the ROMER arm connection.

The older ROMER scanners communicate using:

1. A TCP/IP connection using an Ethernet cable is used to give feedback from the SCANNER.
   
   
2. A USB cable connection is used to send the ball probe position.
   
   
3. A power cable
   
   

You will need one open Ethernet port and one open USB port for the ROMER arm connection.

7-Series Arm Feature Pack

This is the ROMER Scanning Pack that is attached to the back base of the 7-series arms. It includes ports for power, USB, and Ethernet.

If you are using a laser scanner, then the Ethernet cable must be connected and setup with the proper IP address.

Original 8-Series Arm Control Pack

This is the HEXAGON Absolute Arm Control Pack that is attached to the back base of the 8-series arms when the 8-series was originally released. It includes ports for power, USB, and Ethernet.

If you are using a laser scanner, then the Ethernet cable must be connected. These control packs will automatically serve an IP address to your computer.

2021 (Newer) CP-Series Arm Control Pack

This is the HEXAGON Absolute Arm Control Pack that is attached to the back base of the newer 8-series arms. This pack is highly recommended for its simplicity compared to older packs.

It includes ports for power and Ethernet. HEXAGON recommends that it be connected through the included DEXLAN USB to Ethernet adapter.

There is no USB port in the CP-series of control packs. Only an Ethernet cable must be connected. These control packs will automatically serve an IP address to your computer.

The CP-C are cabled control packs.
The CP-W are wireless control packs.

The CP in the picture is a CP-C.