Difference between revisions of "Benderlink for SolidWorks"

Revision as of 14:42, 22 October 2007

Benderlink for Solid Works software is designed to convert from Solid Works to bender data then to connect Solid Works workstations to SVNET-based benders.

If a measuring center arm is setup to sketch a 3D centerline of a measured tube shape, then Benderlink will help you reverse-engineer tube shapes, and assist in correcting the bender's data.

Features

The main features of this software:

1. - Read tube data from Solid Works
2. - Convert the tube data to bender data
3. - Save / Recall the bender data
4. - Send new nominal data to benders that support SVNET protocol.
5. - With a measureing center: Make and send correction data to benders that support the SVNET protocol.
6. - With a measuring center: Reverse-engineer tube shapes

http://advancedtubular.com/blink_sw/help_html/clip0003.jpg

The reverse-engineering feature is performed by using 3D sketch with a measuring center - like a FARO arm. The tube centerline is sketched in 3D, then transferred to Benderlink for Solid Works.

The correction feature is performed by measuring a tube with FARO arm, using this data to create a tube centerline in Solid Works, then allow Benderlink to compare this inspected data with the MASTER data.

Movie

Download and view videos that show how Benderlink for SolidWorks works.

• Introduction to the program:

[for SolidWorks Intro.exe]

Help

Read the help file here.

[1] Read the online help

--Mcone 13:37, 28 July 2006 (EDT)