Difference between revisions of "SE2Bender v3-20080221"
From ATTWiki
| (3 intermediate revisions by one user not shown) | |||
| Line 6: | Line 6: | ||
<br> | <br> | ||
| − | = | + | =CHANGE to IMPORT/EXPORT Engine= |
===[[image:Check.jpg|25px]] Changed to Handle Data for Straight Tubes/Pipes === | ===[[image:Check.jpg|25px]] Changed to Handle Data for Straight Tubes/Pipes === | ||
| Line 15: | Line 15: | ||
| − | + | This is an example of a log message during import for parts with no bends: | |
[[image:Se2bender_nobend.jpg]] | [[image:Se2bender_nobend.jpg]] | ||
| + | |||
| + | <br> | ||
| + | <br> | ||
| + | ==Other Pages== | ||
| + | |||
| + | *Back to the [[SE2Bender]] page | ||
Latest revision as of 19:07, 11 March 2008
CHANGE to IMPORT/EXPORT Engine
Changed to Handle Data for Straight Tubes/Pipes
Previous versions required at least one bend in the tube. However, there are circumstances were only a cut-length of straight tube is the final product. So now SE2Bender can now handle the import of parts with ONE straight and ZERO bends. SE2Bender can also now export the same data to Supravision file with only one straight.
This is an example of a log message during import for parts with no bends:
Other Pages
- Back to the SE2Bender page
