Difference between revisions of "Benderlink for SolidWorks 2.0"
From ATTWiki
| Line 9: | Line 9: | ||
Benderlink now automatically detects bends that have an angle of 180 degrees or more then performs a bisection into two smaller bend angles. This overcomes the problem of an intersection point at an unsolvable intersection by creating two intersection points with two bends where there was one. | Benderlink now automatically detects bends that have an angle of 180 degrees or more then performs a bisection into two smaller bend angles. This overcomes the problem of an intersection point at an unsolvable intersection by creating two intersection points with two bends where there was one. | ||
| − | [[image: | + | [[image:Blinksw_v2_sw180_2.jpg|400px]]<br><br> |
| − | [[image: | + | [[image:Blinksw_v2_sw180_3.jpg|400px]]<br><br> |
[[image:Blinksw_1_9_springback.jpg|400px]]<br><br> | [[image:Blinksw_1_9_springback.jpg|400px]]<br><br> | ||
| − | |||
| − | |||
===[[image:Check.jpg|25px]] Repair - [[TAURING]] Data Includes Straight Distances === | ===[[image:Check.jpg|25px]] Repair - [[TAURING]] Data Includes Straight Distances === | ||
Revision as of 13:00, 22 April 2008
Contents |
New - Now Handles Bends 180 Degrees or Greater
Benderlink now automatically detects bends that have an angle of 180 degrees or more then performs a bisection into two smaller bend angles. This overcomes the problem of an intersection point at an unsolvable intersection by creating two intersection points with two bends where there was one.
Repair - TAURING Data Includes Straight Distances
Benderlink for SolidWorks now includes the straights in the TAURING bender data.
Other Pages
- Back to the Benderlink for SolidWorks page
- The Bend Reduction Editor page describes how to use the editor
