Difference between revisions of "Benderlink for Pines"
From ATTWiki
(→TS-2000 Control to Vector 1 Laservision) |
|||
| Line 1: | Line 1: | ||
| − | + | ||
[[image:Blink_pines_logo.jpg|300px]] | [[image:Blink_pines_logo.jpg|300px]] | ||
=About= | =About= | ||
| − | Benderlink for Pines is software that connects PINES TS2000 controls with Eaton Leonard Vector Laservision measuring centers. | + | |
| + | {| border="0" cellpadding="5" cellspacing="0" align="none" width=600 | ||
| + | |- | ||
| + | | Benderlink for Pines is software that connects PINES TS2000 controls with Eaton Leonard Vector Laservision measuring centers. | ||
| + | | [[image:Blinkpines_v2_mainscreen.jpg|300px]] | ||
| + | |} | ||
| + | |||
| + | |||
| + | |||
Revision as of 00:58, 1 May 2008
Contents |
About
| Benderlink for Pines is software that connects PINES TS2000 controls with Eaton Leonard Vector Laservision measuring centers. | 
|
TS-2000 Control to Vector 1 Laservision
|
The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines. | 
|
Versions
Version 1.0
Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision.
Version 2.0
Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary.
