Difference between revisions of "Benderlink for Pines"
From ATTWiki
(→Version 1.0 - ATT Protocol (Competitive Bender Interface)) |
(→Version 1.0 - ATT Protocol (Competitive Bender Interface)) |
||
| Line 26: | Line 26: | ||
==Version 1.0 - ATT Protocol (Competitive Bender Interface)== | ==Version 1.0 - ATT Protocol (Competitive Bender Interface)== | ||
| − | Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision. Eaton Leonard referred to this as a "Competitive Bender Interface" because it was designed to grant competitors the right to use the measuring center through license charges. | + | {| border="0" cellpadding="5" cellspacing="0" align="none" width=600 |
| − | + | |- | |
| − | [[image:Blinkpines_v1_mainscreen.jpg|200px]] | + | | Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision. Eaton Leonard referred to this as a "Competitive Bender Interface" because it was designed to grant competitors the right to use the measuring center through license charges. |
| + | | [[image:Blinkpines_v1_mainscreen.jpg|200px]] | ||
| + | |} | ||
==Version 2.0== | ==Version 2.0== | ||
Revision as of 01:04, 1 May 2008
Contents |
About
| Benderlink for Pines is software that connects PINES TS-2000 controls with Eaton Leonard Vector Laservision measuring centers. | 
|
TS-2000 Control to Vector 1 Laservision
|
The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines. The protocol used is the Velog/El-2000/Premier protocol - so the software is compatible with Eaton Leonard Vector Laservision out of the box. |
|
Versions
Version 1.0 - ATT Protocol (Competitive Bender Interface)
| Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision. Eaton Leonard referred to this as a "Competitive Bender Interface" because it was designed to grant competitors the right to use the measuring center through license charges. | 
|
Version 2.0
Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary.
Other Pages
Back to the Benderlink Page
