Difference between revisions of "CNC Bender LiteControl 10.0.5.9g"
From ATTWiki
(→CHANGES to CNC BENDER LITECONTROL) |
|||
| (2 intermediate revisions by one user not shown) | |||
| Line 5: | Line 5: | ||
| − | This is a minor change to an older version of CNC Bender LiteControl | + | This is a minor change to an older version of CNC Bender LiteControl. It is only intended to update customers with older 800 x 600 screen operator stations. |
===[[image:Check.jpg|25px]] New General Dynamic OPTION: Allow Monitor for Chuck Close Button === | ===[[image:Check.jpg|25px]] New General Dynamic OPTION: Allow Monitor for Chuck Close Button === | ||
| − | The chuck close button could automatically close the chuck at any point during a bend cycle. | + | |
| + | The chuck close button could automatically close the chuck at any point during a bend cycle. This could cause a problem for customers that skip the run buttons in [[hitch feed]] mode, as the chuck could close at the wrong time during hitch feeding. Customers wanted this prevented, so we've added a General Dynamic Option "Always Monitor for Chuck Close Button" with a default state of DISABLED. | ||
<br><br> | <br><br> | ||
| − | |||
| − | |||
| + | [[image:Cncbender_litcontrol_monitorchuckclose.jpg]] | ||
<br><br> | <br><br> | ||
| Line 19: | Line 19: | ||
=Other Pages= | =Other Pages= | ||
| + | *Read about [[LiteControl]] | ||
*Back to [[CNC Bender]] | *Back to [[CNC Bender]] | ||
*Back to [[CNC Bender Software Updates]] | *Back to [[CNC Bender Software Updates]] | ||
Latest revision as of 02:19, 31 May 2008
Contents |
This is a minor change to an older version of CNC Bender LiteControl. It is only intended to update customers with older 800 x 600 screen operator stations.
New General Dynamic OPTION: Allow Monitor for Chuck Close Button
The chuck close button could automatically close the chuck at any point during a bend cycle. This could cause a problem for customers that skip the run buttons in hitch feed mode, as the chuck could close at the wrong time during hitch feeding. Customers wanted this prevented, so we've added a General Dynamic Option "Always Monitor for Chuck Close Button" with a default state of DISABLED.
If this option is disabled, then CNC Bender will not monitor for the chuck close button unless it is specifically called for in the process list by CNC Processor.
Other Pages
- Read about LiteControl
- Back to CNC Bender
- Back to CNC Bender Software Updates
