Difference between revisions of "CNC Bender Robot Integration"
From ATTWiki
(→Command Setup for Robot Type 1) |
(→Command Setup for Robot Type 1) |
||
| Line 39: | Line 39: | ||
<br><br> | <br><br> | ||
[[image:Cncbender_commandsetup_robot_type1.jpg]] | [[image:Cncbender_commandsetup_robot_type1.jpg]] | ||
| + | <br><br> | ||
| + | The robot_check_fault secondary process is told to start just before the last bend begins, then told to disable at the start of the next cycle (next part). | ||
Revision as of 18:26, 24 July 2008
CNC Bender can integrate to robots for both loading and unloading.
Logic Flow for Robot Type 1 Integration
You can view sample LOAD and UNLOAD logic here for our standard robot (type 1) integration.
|
|
|
|
|
Command Setup for Robot Type 1
This chart shows an example of of the the command set that is used by CNC Bender to integrate to standard robots.
(Note that the input/output point assignment is for bender 16188. The assignment may vary slightly between benders. However, the COMDEF and CIO names will remaine the same):
The robot_check_fault secondary process is told to start just before the last bend begins, then told to disable at the start of the next cycle (next part).
