Difference between revisions of "CNC Bender v11-20090126"
| Line 36: | Line 36: | ||
The upper torque limit in Low Level general dynamic options is no longer used to warn for manual feed moves. This value is intended only for Feed-Bend motion. | The upper torque limit in Low Level general dynamic options is no longer used to warn for manual feed moves. This value is intended only for Feed-Bend motion. | ||
| + | <br><br> | ||
<br><br> | <br><br> | ||
Revision as of 16:31, 28 January 2009
NEW - SAVE and OPEN Tool Set Files from the Tool Page
The tool page now has open and save buttons for TOOL SET FILE management in CNC Bender.
ENHANCE - Adjust General Dynamic Option Name - Feed-Bend Torque Limits
The Low Level names of dynamic options "Feed Torque Safe High" and "Feed Torque Safe Low" were adjusted for clarification.
The new names include "Feed-Bend" inserted in the beginning to be sure users understand that these values are used by the Processlist Builder to limit the feed axis torque during Feed-Bending only. These values have no effect on the torque of the feed axis for any other type of feed motion.
These are the options before the change:
These are the options after the change:
Upgrade Note: When upgrading to this version, it is important to remember to restore the dynamic options in low level in order to see this change take effect.
ENHANCE - Upper Torque Limit No Longer Applies to Manual Feed Moves
The upper torque limit in Low Level general dynamic options is no longer used to warn for manual feed moves. This value is intended only for Feed-Bend motion.
WARNING: Be Careful to Set Proper Torque Limits
|
|
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- Read about Push Bending
- Read about Push Bend Profile Tables
