Difference between revisions of "Pulse Machine Lube Pump"
From ATTWiki
(→How to Determine if the System Should Use Pulse Output) |
(→How to Determine if the System Should Use Pulse Output) |
||
| Line 15: | Line 15: | ||
===How to Determine if the System Should Use Pulse Output=== | ===How to Determine if the System Should Use Pulse Output=== | ||
| − | + | Using a pulsed output is important for pneumatic valves. Pulsing allows the pump to send lube throughout the system. | |
| + | <br><br> | ||
| + | However, '''it is very important to set pulse OFF (0) if your machine uses an electric motor for its lube system.''' | ||
<table cellpadding="15"> | <table cellpadding="15"> | ||
Revision as of 21:28, 28 January 2009
Pulse Machine Lube Pump
What is It?
This is a boolean (on/off) property in the CNCProcessor.cfg file. It is a switch that instructs CNC Processor to pulse the lube actuator during a machine lube event.
Value
The value is set to either 0 (for off) or 1 (for on).
Pulse Machine Lube Pump= 1
How to Determine if the System Should Use Pulse Output
Using a pulsed output is important for pneumatic valves. Pulsing allows the pump to send lube throughout the system.
However, it is very important to set pulse OFF (0) if your machine uses an electric motor for its lube system.
|
|
Other Pages
- Back to CNC Bender Technical Notes
- See Auto Lube for details on how to test the Auto Lube system
- See Configuring Machine Lube Settings
- See CNCProcessor.cfg
