Difference between revisions of "Revision: Benderlink for BLM 3.4"
From ATTWiki
(→Other Pages) |
|||
| (12 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| + | <table> | ||
| + | <tr> | ||
| + | <td> | ||
[[image:Benderlink_blm_logo.jpg|350px]]<br><br> | [[image:Benderlink_blm_logo.jpg|350px]]<br><br> | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:Blm_e-bend76.jpg|250px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
__NOTOC__ | __NOTOC__ | ||
| − | |||
| − | |||
| + | ===[[image:Check.jpg|25px]] NEW User Interface=== | ||
| + | |||
| + | We've updated the look of Benderlink for BLM with a new user interface. | ||
| + | |||
| + | <br> | ||
| + | [[image:blinkblm_v3.5.jpg|400px]] | ||
<br><br> | <br><br> | ||
| − | === | + | ===[[image:Check.jpg|25px]] NEW Checkbox Setting: Always Use BLM File Name as Internal Part Number === |
| − | + | ||
| − | + | This new switch value allows you to always synchronize the internal part number with the file name being imported. | |
| + | |||
| + | <br> | ||
| + | [[image:blinkblm_bender_network_setup.jpg|500px]] | ||
| + | |||
| + | <br><br> | ||
| + | |||
| + | ===[[image:Check.jpg|25px]] CHANGE - BLM Requested Removal of Variable Radius Bending Recognition=== | ||
| + | |||
| + | In previous versions, Benderlink would attempt to recognize BLM push bends. BLM technicians requested that we remove the feature from Benderlink. This version no longer attempts to detect this kind of bender. | ||
| + | |||
| + | |||
| + | <br><br> | ||
| + | |||
| + | ==Other Pages== | ||
| + | |||
| + | *Go back to [[Benderlink]] | ||
| + | *Go back to [[Benderlink for BLM]] | ||
| + | *Go to the [http://www.advancedtubular.com/blink_blm.htm main Benderlink for BLM page] | ||
| + | *About [[BLM]] Group USA | ||
Latest revision as of 04:08, 12 February 2009
|
|
|
NEW User Interface
We've updated the look of Benderlink for BLM with a new user interface.
NEW Checkbox Setting: Always Use BLM File Name as Internal Part Number
This new switch value allows you to always synchronize the internal part number with the file name being imported.
CHANGE - BLM Requested Removal of Variable Radius Bending Recognition
In previous versions, Benderlink would attempt to recognize BLM push bends. BLM technicians requested that we remove the feature from Benderlink. This version no longer attempts to detect this kind of bender.
Other Pages
- Go back to Benderlink
- Go back to Benderlink for BLM
- Go to the main Benderlink for BLM page
- About BLM Group USA
