Difference between revisions of "Benderlink for Crown"
From ATTWiki
(→Benderlink Module Used with Crown) |
|||
| (One intermediate revision by one user not shown) | |||
| Line 1: | Line 1: | ||
[[image:Crownbender.jpg|right]] | [[image:Crownbender.jpg|right]] | ||
| − | + | [[image:Blinkcrown_v3_1.jpg|300px]] | |
| − | [[image: | + | |
| Line 13: | Line 12: | ||
[[image:Blink_elmodule_crown2.jpg|250px]] | [[image:Blink_elmodule_crown2.jpg|250px]] | ||
| − | This Benderlink Module is used to link a Crown bender to two | + | This Benderlink Module is used to link a Crown bender to two Eaton Leonard [[Vector Tube Data Center]]s measuring centers. See [[Benderlink Module - Laservision to Crown]] for more information. |
| + | |||
| + | ===Versions=== | ||
| + | |||
| + | *[[Benderlink for Crown Version 2.2]] | ||
| + | [[image:Blinkcrown.jpg|150px]] | ||
| + | <br> | ||
| + | <br> | ||
| + | |||
| + | *[[Benderlink for Crown Version 3.1]] - September 7, 2007 | ||
| + | [[image:Blinkcrown_v3_1.jpg|150px]] | ||
Latest revision as of 13:19, 12 February 2009
Benderlink for Crown is designed to run within the operating station of the Crown bender.
See this web page for more information: http://www.advancedtubular.com/blink_crowneb.htm
Benderlink Module Used with Crown
This Benderlink Module is used to link a Crown bender to two Eaton Leonard Vector Tube Data Centers measuring centers. See Benderlink Module - Laservision to Crown for more information.
Versions
- Benderlink for Crown Version 3.1 - September 7, 2007
