Difference between revisions of "TubeCAD - Blockups With Angles"
From ATTWiki
(→Modified Blockups) |
|||
| (4 intermediate revisions by one user not shown) | |||
| Line 5: | Line 5: | ||
== Step 1 == | == Step 1 == | ||
| − | Right click and choose Global | + | Right click and choose Global Layout Settings<br> |
[[image:tcad_blockup_withangle2.jpg|400px]] | [[image:tcad_blockup_withangle2.jpg|400px]] | ||
== Step 2== | == Step 2== | ||
| − | Choose Blockups<br> | + | *Choose Blockups (in the list on the left) |
| + | *Calculation Mode (in the properties list on the right) | ||
| + | *Set the mode to Low Profile with Angles | ||
| + | *Click on OK | ||
| + | <br> | ||
[[image:tcad_blockup_withangle3.jpg|400px]] | [[image:tcad_blockup_withangle3.jpg|400px]] | ||
| − | == | + | == Modified Blockups== |
The modified blockups<br> | The modified blockups<br> | ||
[[image:tcad_blockup_withangle4.jpg|400px]] | [[image:tcad_blockup_withangle4.jpg|400px]] | ||
| + | |||
| + | |||
| + | == Other Pages == | ||
| + | |||
| + | Go back to [[TubeCAD Pro]] | ||
Latest revision as of 15:12, 26 February 2009
Follow these steps to set blockups to use angles:
Contents |
Start: Blockups without angles
Step 1
Right click and choose Global Layout Settings
Step 2
- Choose Blockups (in the list on the left)
- Calculation Mode (in the properties list on the right)
- Set the mode to Low Profile with Angles
- Click on OK
Modified Blockups
The modified blockups
Other Pages
Go back to TubeCAD Pro
