Latest revision as of 16:19, 21 January 2010

A Jog Motion is a motion for a single axis or actuator that is stored in a Custom Command for use by Teach Mode if you choose to teach the bender. (See Screen 1)

Custom Commands begin without any Jog Motions (See Screen 2) Add a Jog Motion using the Add a jog motion button

Now the Jog Motion exists, but it is unassigned or empty. Click on the Jog Motion name cell to select a Jog Motion. (See Screen 3)

Jog Motions are selected from the Jog Motion Selection menu by touching the Jog Motion name cell in a Custom Command menu (See Screen 4)

Multiple Jog Motions can be stored in a single Custom Command. When they are combined in a single Custom Command, then CNC Processor runs them all at the same time.

Screen 4: Select a Jog Motion from the Selection menu

Screen 1: Three Jog Motions in a Custom Command - All three run at the same time.

Screen 2: An empty Custom Command (no Jog Motions present)

Screen 3: Click on an unassigned (empty) Jog Motion cell to select a Jog Motion

Jog Motion System Configuration

The existence of a Jog Motion in the CNC Bender user interface is completely configurable.

You can add or edit your own Jog Motion or remove the existing Jog Motions from the user interface using a single configuration file.

You can even rename the Jog Motion name (or translate the motion to another language).

@@ Line 1: / Line 1: @@
+[[image:cncv12procontrol_withteachmode.jpg|300px]]
+[[image:v12teachmode_buildcustomcommand.jpg|500px]]
 <table>
 <tr valign=top>
@@ Line 32: / Line 35: @@
-==Jog Motion Configuration==
+==Jog Motion System Configuration==
 <table>
@@ Line 47: / Line 50: @@
 </tr>
 </table>
+<br><br>
+=Other Pages=
+*Back to [[CNC Bender]]
+*Back to [[CNC Bender Software Updates]]
+*See [[CNC Bender General Information]]
+*See [[Teach Mode]]
+*See [[Custom Command]]s
+*See upgrade [[CNC Bender v12-20100105]]