Latest revision as of 16:59, 25 March 2010

Type of Upgrade: Minor Upgrade

Recovery Rotate Logic Enhancement

@@ Line 11: / Line 11: @@
 </td>
 <td>
-Machine Lube Logic Adjustment
+Recovery Rotate Logic Enhancement
 </td>
 </tr>
@@ Line 24: / Line 24: @@
 __TOC__
+===[[image:Check.jpg|25px]] ENHANCED- Rotation Recovery Shortest Angle Possible===
+<table>
+<tr valign=top>
+<td width=300>
+When a rotation is stopped and recovered by stepping on the safety mat, the rotation direction would not always move the shortest angle and direction to recover.
+<br><br>
+This has been resolved so that all non-linear axes recover in the direction that is measured as the shortest possible angle.
+</td>
+<td>
+</td>
+</tr>
+<tr valign=top>
+<td width=300>
+</td>
+<td>
+</td>
+</tr>
+</table>
 ===[[image:Check.jpg|25px]] DEBUG - Machine Lube Timer Logic===
@@ Line 48: / Line 71: @@
 </table>
-<br><br>
+===[[image:Check.jpg|25px]] ADDED - Cycle Hold After Last Bend After Dies Open===
-===[[image:Check.jpg|25px]] ADDED - Cycle Hold After Dies Open in Post Bend===
 <table>
 <tr valign=top>
 <td width=300>
-This feature was requested so we added it to CNC Bender.<br><br>
+This feature was requested so we added it to CNC Bender.
+<br><br>
+Now the bender will go into cycle hold after the last bend after the dies open if this option is switched ON in the last bend cell (part release) section.
 </td>
 <td>

Difference between revisions of "CNC Bender v12-20100324"

When a rotation is stopped and recovered by stepping on the safety mat, the rotation direction would not always move the shortest angle and direction to recover. This has been resolved so that all non-linear axes recover in the direction that is measured as the shortest possible angle.

A small bug was removed in the machine lube timer that would prevent the machine lube from starting. The Machine Lube feature shares the Constant Run List timer. This error was only encountered recently because we have begun running CNC Processor loops faster than in previous versions.

This feature was requested so we added it to CNC Bender. Now the bender will go into cycle hold after the last bend after the dies open if this option is switched ON in the last bend cell (part release) section.