Difference between revisions of "CNC Bender v12-20101005"
From ATTWiki
| (2 intermediate revisions by one user not shown) | |||
| Line 20: | Line 20: | ||
</td> | </td> | ||
<td> | <td> | ||
| − | [[image:loadstart_runpage.jpg| | + | [[image:loadstart_runpage.jpg|350px]] |
</td> | </td> | ||
</tr> | </tr> | ||
| Line 32: | Line 32: | ||
<td width=200> | <td width=200> | ||
The FEED axis values can be displayed from the front or the back by pressing a toggle button in the RUN PAGE.<br><br> | The FEED axis values can be displayed from the front or the back by pressing a toggle button in the RUN PAGE.<br><br> | ||
| + | This changes all FEED Position values displayed in CNC Bender. | ||
</td> | </td> | ||
<td> | <td> | ||
| − | + | [[image:feeddatum_change.jpg|350px]] | |
</td> | </td> | ||
</tr> | </tr> | ||
| Line 40: | Line 41: | ||
</table> | </table> | ||
| − | |||
===[[image:Check.jpg|25px]] NEW - FEED TORQUE ZEROED DURING MANDREL RETRACT === | ===[[image:Check.jpg|25px]] NEW - FEED TORQUE ZEROED DURING MANDREL RETRACT === | ||
Latest revision as of 14:01, 7 October 2010
|
|
Contents |
NEW - LOAD and START in RUN PAGE
|
The LOAD and START values can now be programmed in the RUN PAGE. |
|
NEW - FEED AXIS POSITION DISPLAY FROM BACK OR FRONT
|
The FEED axis values can be displayed from the front or the back by pressing a toggle button in the RUN PAGE. |
|
NEW - FEED TORQUE ZEROED DURING MANDREL RETRACT
|
The FEED TORQUE is now set to ZERO% during mandrel retractions. This prevents possible destruction of the FEED gearbox, rack, pinion, chain, if the tube breaks during bending and the mandrel pulls the tube and carriage back. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
