Difference between revisions of "Change the default linear units in VTube"
From ATTWiki
(→Other Pages) |
|||
| (4 intermediate revisions by one user not shown) | |||
| Line 8: | Line 8: | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
| − | [[image:Vtube- | + | [[image:Vtube-step_1_651.jpg|300px]]<br> |
| − | [[image:vtube- | + | [[image:vtube-laser_screen_1_541.jpg|300px]] |
</td> | </td> | ||
</tr> | </tr> | ||
| Line 25: | Line 25: | ||
Use the toolbar buttons to clear VTube and press the Linear Units button until the correct units are active.</td> | Use the toolbar buttons to clear VTube and press the Linear Units button until the correct units are active.</td> | ||
<td> | <td> | ||
| − | [[image:vtube- | + | [[image:vtube-step_toolbar_clear_units1.jpg|600px]] |
</td> | </td> | ||
</tr> | </tr> | ||
| Line 32: | Line 32: | ||
Press the System Options button.</td> | Press the System Options button.</td> | ||
<td> | <td> | ||
| − | [[image:vtube- | + | [[image:vtube-step_toolbar_sys1.jpg|400px]] |
</td> | </td> | ||
</tr> | </tr> | ||
| Line 39: | Line 39: | ||
Press the Project Setup tab, and then press the Set Project Default State button.</td> | Press the Project Setup tab, and then press the Set Project Default State button.</td> | ||
<td> | <td> | ||
| − | [[image:vtube- | + | [[image:vtube-step_setprojdefaultstate1.jpg|400px]] |
</td> | </td> | ||
</tr> | </tr> | ||
Latest revision as of 14:23, 25 May 2022
|
|
|
Steps to changing the default linear units
| Use the toolbar buttons to clear VTube and press the Linear Units button until the correct units are active. |
|
| Press the System Options button. |
|
| Press the Project Setup tab, and then press the Set Project Default State button. |
|
|
Exit the System Options menu. VTube will now clear to the new linear unit. |
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
