Difference between revisions of "CNC Bender v12-20111229"
From ATTWiki
| (15 intermediate revisions by one user not shown) | |||
| Line 13: | Line 13: | ||
</table> | </table> | ||
__NOTOC__ | __NOTOC__ | ||
| − | ===[[image:Check.jpg|25px]] REPAIR - Pressure Die Interference Zone === | + | ===[[image:Check.jpg|25px]] REPAIR - Pressure Die Interference Zone Collision Logic Change === |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=400> | <td width=400> | ||
| − | * The pressure die interference logic would stop the bending with a collision | + | * '''THE ISSUE'''<br>The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis. |
| − | * | + | <br> |
| + | * '''THE REPAIRED LOGIC'''<br>Now if the PDA is a servo axis and GEARING is switched on in the bend arm servo module, then the potential for collision is ignored . This will assume that the pressure die assist is geared to the bend axis and is moving forward with the bend arm. | ||
</td> | </td> | ||
| Line 30: | Line 31: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | + | <br><br> | |
| − | + | ||
| − | + | ||
=Other Pages= | =Other Pages= | ||
Latest revision as of 18:56, 29 December 2011
v12-20111229
|
|
REPAIR - Pressure Die Interference Zone Collision Logic Change
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
