Difference between revisions of "CNC Bender v12-20111229"

From ATTWiki
Jump to: navigation, search
(25px REPAIR - Pressure Die Interference Zone)
(25px REPAIR - Pressure Die Interference Zone Collision Logic Change)
 
(14 intermediate revisions by one user not shown)
Line 13: Line 13:
 
</table>
 
</table>
 
__NOTOC__
 
__NOTOC__
===[[image:Check.jpg|25px]] REPAIR - Pressure Die Interference Zone  ===
+
===[[image:Check.jpg|25px]] REPAIR - Pressure Die Interference Zone Collision Logic Change ===
  
 
<table cellpadding=10>
 
<table cellpadding=10>
 
<tr valign=top>
 
<tr valign=top>
 
<td width=400>
 
<td width=400>
* The pressure die interference logic would stop the bending with a collision fault if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis.
+
* '''THE ISSUE'''<br>The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis.
<br><br>
+
<br>
* This has been resolved with this version.  If the PDA is a servo axis, then the potential for collision is ignored.
+
* '''THE REPAIRED LOGIC'''<br>Now if the PDA is a servo axis and GEARING is switched on in the bend arm servo module, then the potential for collision is ignored .  This will assume that the pressure die assist is geared to the bend axis and is moving forward with the bend arm.
  
 
</td>
 
</td>
Line 31: Line 31:
 
</tr>
 
</tr>
 
</table>
 
</table>
 
+
<br><br>
===[[image:Check.jpg|25px]] Other  ===
+
 
+
  
 
=Other Pages=
 
=Other Pages=

Latest revision as of 18:56, 29 December 2011

v12-20111229

Cncv12procontrol withteachmode.jpg

Check.jpg REPAIR - Pressure Die Interference Zone Collision Logic Change

  • THE ISSUE
    The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis.


  • THE REPAIRED LOGIC
    Now if the PDA is a servo axis and GEARING is switched on in the bend arm servo module, then the potential for collision is ignored . This will assume that the pressure die assist is geared to the bend axis and is moving forward with the bend arm.




Other Pages