Difference between revisions of "End-Scan Technique Research"

Latest revision as of 20:34, 25 September 2013

End Scan Technique Research

@@ Line 19: / Line 19: @@
 <tr valign=top>
 <td width=500>
-* [[End-Scan Using the Scissor Motion]]
+* LASER - [[End-Scan Using the Scissor Motion]]
-* [[End-Scan Using the End Wall]]
+* LASER - [[End-Scan Using the End Wall]]
-* [[End-Scan Using End Targets]]
+* LASER - [[End-Scan Using End Targets]]
+* TACTILE - [[End-Scan Using a Ball Probe]]
 </td>
 <td width=300>
+[[image:EndTargetPlugDesign.jpg|300px]]
 </td>
 </tr>
 </table>
-===Measure Setup===
+===Other End-Scan Information===
 <table cellpadding=10>
 <tr valign=top>
 <td width=500>
-* Set System Options, Measure 2 Tab, "Maximum Number of LLP Points in String" to 3
+* [[VTube-LASER - End Scan Diameter Qualification Tolerance]]
-* Set Measure Setup - LASER Tab: The LASER defaults to ON for CYLINDERS and END-SCANS.
-* Set Measure Setup - LASER Tab: Cylinder stripes = 3 to 5
-* Set Measure Setup - LASER Tab: End-scan stripes = 5
-* Set Measure Setup - LASER Tab: Split bend stripes = 5
-* Set Measure Setup = Scan Rates Tab: Set all rates to TIMER for all scan types.
-* Set Measure Setup = Scan Rates Tab: Set the Scan Rates TIMER is set to 0 for all TIMERS.
 </td>
 <td width=300>
 </td>
 </tr>
 </table>
 ===Other Pages===
-* See also [[End-Scan Using the End Wall]]
-* See also [[End-Scan Using End Targets]]
 * Back to [[VTube-LASER]]