Difference between revisions of "CNC Bender v12.1.1"
From ATTWiki
(→25px Other Changes) |
|||
| (5 intermediate revisions by one user not shown) | |||
| Line 2: | Line 2: | ||
<tr> | <tr> | ||
<td width=400> | <td width=400> | ||
| − | ===v12.1 - August | + | ===v12.1.1 - August 26, 2013=== |
*Back to [[CNC Bender Software Updates]] | *Back to [[CNC Bender Software Updates]] | ||
*See [http://advancedtubular.com/customers/cncbender CNC Bender Customer Service Page] for an update. | *See [http://advancedtubular.com/customers/cncbender CNC Bender Customer Service Page] for an update. | ||
| Line 27: | Line 27: | ||
==[[image:Check.jpg|25px]] ENHANCED: CNC Bender Benderlink Can Emulated Hyprex Laservision== | ==[[image:Check.jpg|25px]] ENHANCED: CNC Bender Benderlink Can Emulated Hyprex Laservision== | ||
| − | Hyprex Laservision | + | CNC Bender Benderlink can emulate the Hyprex Laservision mode which handles 21 characters in the part name rather than 14 characaters.<br><br> |
| + | [[image:cncbender_12.1_benderlink_hyprex.png|500px]] | ||
==[[image:Check.jpg|25px]] Other Changes== | ==[[image:Check.jpg|25px]] Other Changes== | ||
| Line 33: | Line 34: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| + | |||
| + | * Forward PDA Outputs are cleared when the operator enters CYCLE HOLD. No other outputs are changed when this event occurs. | ||
</td> | </td> | ||
Latest revision as of 17:52, 28 August 2013
v12.1.1 - August 26, 2013
|
|
FIX: FRB Clear Part Fixed
CNC Bender would save parts after a FRB clear by default in the c:\cnc\config folder. This was repaired so that it saves inside the the correct parts folder.
NEW: Processor Now Checks to See if Inputs are Internal
CNC Processor can now check if an input is an internal input that is not connected to a physical input. This is used for setting and reading states inside the Processor without using actual physical I/O.
FIX: CNC Bender Benderlink Fix with Laservision
CNC Bender Benderlink would sometimes return an out-of-bounds error after receiving Laservision data. This was related to setting the first straight adjustment value to zero. It has been resolved.
ENHANCED: CNC Bender Benderlink Can Emulated Hyprex Laservision
CNC Bender Benderlink can emulate the Hyprex Laservision mode which handles 21 characters in the part name rather than 14 characaters.
Other Changes
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
