Difference between revisions of "Safe Mode Motion Auto Recovery"

From ATTWiki
Jump to: navigation, search
 
(10 intermediate revisions by one user not shown)
Line 1: Line 1:
_toc_
+
[[image:cncbender_logo.jpg|400px]]<br>
 +
[[image:cncbender_operatorstation.jpg|200px|right|]]
 +
 
 +
__TOC__
  
 
==Basic Description==
 
==Basic Description==
Line 12: Line 15:
 
This is true of the primary and all secondary [[processlist]]s running at the same time.<br><br>
 
This is true of the primary and all secondary [[processlist]]s running at the same time.<br><br>
  
 
+
==How To Get This Feature==
''Note:  This feature is available on CNC Bender software versions 10-20070425 and higher.  The feature is available for installation on older systems, but requires that the older system electronics be upgraded.''
+
This feature is available on CNC Bender software versions 10-20070425 and higher.  It can be installed on older systems.  The installation requires an on-site visit from an Advanced Tubular technician.  Please contact either SMT or Advanced Tubular for more information about how to upgrade your benders to include this feature.

Latest revision as of 20:39, 17 October 2008

Cncbender logo.jpg

Cncbender operatorstation.jpg

Contents


Basic Description

CNC Bender motion can recover and complete any controlled motion from any "Safe Mode Cycle Hold" state to a Cycle Start condition.

This includes Auto Mode motion, Step Mode motion, and Controlled Jog motion.

How It Works

If an operator steps on the mat in the middle of any motion, the SMT bender comes to a zero-energy state immediately. All axes are disabled. When the operator presses Cycle Start, then the bender will recover from the disabled state, re-enable the axes, calculate the remaining motion, and then complete all motion.

All Processlist Types

This is true of the primary and all secondary processlists running at the same time.

How To Get This Feature

This feature is available on CNC Bender software versions 10-20070425 and higher. It can be installed on older systems. The installation requires an on-site visit from an Advanced Tubular technician. Please contact either SMT or Advanced Tubular for more information about how to upgrade your benders to include this feature.