Difference between revisions of "CNC Bender v11-20081106"
From ATTWiki
| (5 intermediate revisions by one user not shown) | |||
| Line 3: | Line 3: | ||
__NOTOC__ | __NOTOC__ | ||
| + | |||
| + | |||
| + | This upgrade applies primarily to benders that use a motion-controlled PDA (pressure die assist) axis. The change allows the bender to open the clamp and pressure dies separately. | ||
| + | <br><br> | ||
=CHANGES to CNC BENDER= | =CHANGES to CNC BENDER= | ||
| − | ===[[image:Check.jpg|25px]] NEW - Process List Builder | + | ===[[image:Check.jpg|25px]] NEW - Process List Builder Handles Pressure Die and PDA Axis Home Motion === |
The Process List Builder can now move the Pressure Die and PDA Axis home independently of the clamp die when the PDA mode is set to "motion-control". | The Process List Builder can now move the Pressure Die and PDA Axis home independently of the clamp die when the PDA mode is set to "motion-control". | ||
<br> | <br> | ||
| Line 19: | Line 23: | ||
</pre> | </pre> | ||
<br> | <br> | ||
| − | <br> | + | <br> |
| − | + | ||
===[[image:Check.jpg|25px]] NEW - Report missing COMDEFs in the Process List === | ===[[image:Check.jpg|25px]] NEW - Report missing COMDEFs in the Process List === | ||
| Line 31: | Line 34: | ||
</pre> | </pre> | ||
| − | + | <br> | |
| − | + | <br> | |
| − | + | ||
| − | <br><br> | + | |
=Other Pages= | =Other Pages= | ||
Latest revision as of 15:26, 6 November 2008
This upgrade applies primarily to benders that use a motion-controlled PDA (pressure die assist) axis. The change allows the bender to open the clamp and pressure dies separately.
CHANGES to CNC BENDER
NEW - Process List Builder Handles Pressure Die and PDA Axis Home Motion
The Process List Builder can now move the Pressure Die and PDA Axis home independently of the clamp die when the PDA mode is set to "motion-control".
NEW - Pressure Die and PDA Move Home Command
This new command is for moving the Pressure Die and PDA Axis home.
Pressure Die and PDA Motion Home = pos0:0.00000000, vel0:1.00000000, ump0:1, cto:6000
NEW - Report missing COMDEFs in the Process List
Now CNC ProcessList Builder will report missing COMDEF commands in the process list as extra notes. These notes will not stop the bend program, but will act as an aid in diagnosing missing COMDEF issues.
Here is an example:
// ** COMDEF Not Found in Dictionary: Set_IBR_WaitingForChuckClose_OFF **
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- Read about Push Bending
- Read about Push Bend Profile Tables
