Difference between revisions of "TubeCAD - Blockups With Angles"
From ATTWiki
(→Step 1) |
(→Step 2) |
||
| Line 9: | Line 9: | ||
== Step 2== | == Step 2== | ||
| − | Choose Blockups<br> | + | *Choose Blockups (in the list on the left) |
| + | *Calculation Mode (in the properties list on the right) | ||
| + | *Set the mode to Low Profile with Angles<br> | ||
[[image:tcad_blockup_withangle3.jpg|400px]] | [[image:tcad_blockup_withangle3.jpg|400px]] | ||
Revision as of 15:10, 26 February 2009
Follow these steps to set blockups to use angles:
Contents |
Start: Blockups without angles
Step 1
Right click and choose Global Layout Settings
Step 2
- Choose Blockups (in the list on the left)
- Calculation Mode (in the properties list on the right)
- Set the mode to Low Profile with Angles
Step 3
The modified blockups
