Difference between revisions of "Revision: Benderlink for BLM 4"
| Line 41: | Line 41: | ||
[[image:blinkblm_help.jpg|350px]] | [[image:blinkblm_help.jpg|350px]] | ||
| + | |||
| + | <br><br> | ||
| + | |||
| + | |||
| + | <table> | ||
| + | <tr> | ||
| + | <td width=250> | ||
| + | *[http://advancedtubular.com/blink_blm/help_html/ Read the online HELP] | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:blinkblm_online_help.jpg|200px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
<br><br> | <br><br> | ||
Revision as of 07:41, 17 April 2009
|
|
|
NEW - Completely Redesigned Interface
The interface has been updated and reorganized for easier reading with many new features for ease-of-use.
- New - Quick Load and Merge BLM Buttons
- New - Large LED numbers that indicate, in real-time, the byte count coming or going.
- New - Large Monitor speed button for switching between MONITOR ON/OFF for waiting on measuring center commands.
- New - Four new Date/Time labels show when data was last transmitted in any direction
- New - Attention Grabber Logs that flash when the operator should know that something important just happened in the logs
ENHANCED - Updated Eaton Leonard Protocol Handling
This Benderlink now communicates with Eaton Leonard measuring centers using our new current-loop technology that is compatible with the Eaton Leonard legacy protocol. The new engine for communication handling is much improved over older versions.
NEW - New Help and Manual
The manual and help system are completely rewritten with new information that includes...
- how to install Benderlink
- how to install the Benderlink Ethernet Module
- how to use the software - in much more depth
|
|
NEW - Edit the BLM YBC Data Before Sending the Corrected Data to the Bender
This new capability allows the user to fine-tune the corrections before they are sent to the BLM. For example, a 270 degree rotation can be switched to a -90 degree rotation with the press of an inversion button.
New - Check for Matching Part Number - Either ON or OFF
This new feature allows you to setup new parts and ignore the part number during transmission. Or you can prevent accidents by making the two systems pay attention to the part name.
New - Confirmation PING for the Benderlink Module
If the Benderlink Ethernet Module responds to a PING, then it is ready for communication with Benderlink. This test makes the testing for working networks easy.
New - Setup and Diagnostic Utilties for the Benderlink Ethernet Module
The Benderlink Ethernet Module support software is included in the interface of Benderlink for easy access.
Other Pages
- Go back to Benderlink
- Go back to Benderlink for BLM
- Go to the main Benderlink for BLM page
- About BLM Group USA
