Difference between revisions of "Overbend Calculator"
From ATTWiki
| Line 8: | Line 8: | ||
<br> | <br> | ||
| − | [[image:Overbend_calculator_page1.jpg| | + | [[image:Overbend_calculator_page1.jpg|400px]]<br> |
This is software that calculates overbend necessary to overcome springback in bends. | This is software that calculates overbend necessary to overcome springback in bends. | ||
Revision as of 18:48, 16 May 2009
 |
Reduce Scrap & Save Material by Predicting Springback BEFORE Bending the Part |
This is software that calculates overbend necessary to overcome springback in bends.
Three Step Process for Predicting Springback
- STEP 1: Two test bends are made. Typically they are 20 and 120 degrees. The bender is set to bend these angles and a test tube is bent.
- STEP 2: The actual resulting bend angles are measured and entered into the overbend calculator.
- STEP 3: Two values called "proportional" and "fixed" are calculated and used in a springback formula to predict overbend to overcome springback at any angle.
Download Page
Download Overbend Calculator 30-day Trial Package (Shareware)
