Difference between revisions of "Wiring: Power to Mitsubishi RESET pin when E-Stop"
From ATTWiki
(→Wire Jump) |
(→llll) |
||
| Line 9: | Line 9: | ||
[[image:MitusubishiResetLines02.jpg|400px]]<br> | [[image:MitusubishiResetLines02.jpg|400px]]<br> | ||
| − | == | + | ==STEP 2: Attach a Power Line== |
| + | Tap into power by finding wires 2432 at the terminal strip. Run a wire from the strip up to an into point 21 of the M-1 contactor<br> | ||
| + | |||
[[image:MitusubishiResetLines03.jpg|400px]]<br> | [[image:MitusubishiResetLines03.jpg|400px]]<br> | ||
[[image:MitusubishiResetLines04.jpg|400px]]<br> | [[image:MitusubishiResetLines04.jpg|400px]]<br> | ||
| + | |||
| + | ==1111== | ||
[[image:MitusubishiResetLines05.jpg|400px]]<br> | [[image:MitusubishiResetLines05.jpg|400px]]<br> | ||
[[image:MitusubishiResetLines06.jpg|400px]]<br> | [[image:MitusubishiResetLines06.jpg|400px]]<br> | ||
[[image:MitusubishiResetLines07.jpg|400px]]<br> | [[image:MitusubishiResetLines07.jpg|400px]]<br> | ||
| − | |||
==Other Pages== | ==Other Pages== | ||
Revision as of 23:55, 24 June 2009
Contents |
About
This wiring scheme may not exist on older SMT benders. The wiring allows for power to run to the RESET pin on the Mitsubishi drive whenever the Master Power and Safety Relay Contactors are deenergized. This clears the Mitsubishi drives of any faults.
STEP 1: Wire Jump
Wire jump point 22 in M-1 to point 22 in M-2
STEP 2: Attach a Power Line
Tap into power by finding wires 2432 at the terminal strip. Run a wire from the strip up to an into point 21 of the M-1 contactor
1111
Other Pages
- Back to the CNC Bender Page
- Back to the CNC Bender Technical Notes Page
