Difference between revisions of "CNC Bender v11-20090928"
| Line 12: | Line 12: | ||
===[[image:Check.jpg|25px]] NEW - Separate Part Release Mandrel Retract Command for Faster Cycles === | ===[[image:Check.jpg|25px]] NEW - Separate Part Release Mandrel Retract Command for Faster Cycles === | ||
| − | Now the final [[Mandrel Retract]] command is unique from all other [[Mandrel Retract]] commands | + | Now the final [[Mandrel Retract]] command is unique from all other [[Mandrel Retract]] commands.<br><br> |
Since this feature allows CNC Bender to treat the in-bend mandrel retractions separately from the last mandrel retraction, you can increase a pause after the final mandrel retraction while decreasing or eliminating the pauses or prox switch examinations in the in-bend mandrel retractions - thus shaving cycle time. | Since this feature allows CNC Bender to treat the in-bend mandrel retractions separately from the last mandrel retraction, you can increase a pause after the final mandrel retraction while decreasing or eliminating the pauses or prox switch examinations in the in-bend mandrel retractions - thus shaving cycle time. | ||
Revision as of 06:04, 29 September 2009
NEW - Simultaneous Absolute Rotate DURING Final Feed Clearance
This version of CNC Bender uses secondary process lists to set the Absolute Rotate position in the chuck while the Final Feed Clearance move is in action.
This can trim seconds off the part cycle - especially in cases where the Absolute Rotate Offset Position is far from zero degrees.
NEW - Separate Part Release Mandrel Retract Command for Faster Cycles
Now the final Mandrel Retract command is unique from all other Mandrel Retract commands.
Since this feature allows CNC Bender to treat the in-bend mandrel retractions separately from the last mandrel retraction, you can increase a pause after the final mandrel retraction while decreasing or eliminating the pauses or prox switch examinations in the in-bend mandrel retractions - thus shaving cycle time.
|
In-Bend Mandrel Retract Command |
MandrelRetract |
|
New Part Release Mandrel Retract Command |
MandrelRetract_PartRelease |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
