Difference between revisions of "CNC Bender v11-20091007"
Line 13: | Line 13: | ||
So now the new Rotate Reset Mode allows you to control if the rotate axis is reset to zero between every bend by default. | So now the new Rotate Reset Mode allows you to control if the rotate axis is reset to zero between every bend by default. | ||
<br><br> | <br><br> | ||
− | If you intend to use Absolute Pre-Rotate Enable with multiple parts in the Runlist, and the axis should never reset itself except when homing, then the Rotate Reset mode can be set to DISABLE. | + | If you intend to use Absolute Pre-Rotate Enable (See [[Absolute Rotate]]) with multiple parts in the Runlist, and the axis should never reset itself except when homing, then the Rotate Reset mode can be set to DISABLE. |
<br><br> | <br><br> | ||
The default mode is ENABLED - (Reset the rotate axis to zero between bends). | The default mode is ENABLED - (Reset the rotate axis to zero between bends). |
Revision as of 16:15, 7 October 2009
NEW - Low Level - Rotate Reset Mode
By default, the ROTATE AXIS is reset to ZERO degrees between all bends in auto mode. However, there are customer applications where it makes better sense for the rotate axis angle to never reset rotate position.
|
NEW - Low Level - Bend Axis PID Insert Mode
The Bend Axis PID Insert Mode controls if the PID COMDEFs are inserted (or not) into the processlist.
|
It examines the bending mode - either push-bend or draw-bend, to select which PID command is inserted in the processlist. Push-bend bend arm motion can move very slowly - a fact that can be used to tune the axis in that condition for extreme high-precision without creating problems. Draw-bending bend arm motion needs to be faster, so the axis can be tuned for lower-precision.
|
NEW - Spacebar Filter Mode
NEW - Notes Included in General Section of Reports
Customers have asked us to display the note data from the General Setup in all report. So now this data is automatically included in any CNC Bender report that displays the General section.
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Absolute Rotate
- See Absolute Rotate Offset Position
- See Final Feed Clearance
- See Mandrel Retract
- See Mandrel Retract Part Release