Difference between revisions of "Modicon Momentum"
(→INPUT Base with Ethernet Communication Adapter) |
(→BACK of Modicon Momentum I/O Base) |
||
| Line 46: | Line 46: | ||
==BACK of Modicon Momentum I/O Base== | ==BACK of Modicon Momentum I/O Base== | ||
| − | This is the back of the base. | + | This is the back of the base with a channel for receiving a DIN rail. |
[[image:tsxmomentum_back.jpg|300px]] | [[image:tsxmomentum_back.jpg|300px]] | ||
Revision as of 12:33, 23 December 2009
Contents |
About the Modicon Momemtum Package
This the form of the modules that are installed to machines that use our CNC Bender software. The different modules come in a variety of functions - but the same packaging. For example, the image above shows an INPUT base with 32-points with an Ethernet Communications Adapter clipped on the top.
See this data sheet (16 pages) for an overview of these modules.
View the Modicon Momentum I/O Base User Guide (662 pages).
They mount to DIN rails in electrical panels.
I2T IFC220E Servo Modules
The I2T (Pronounced "I Square T") servo modules use the same package form as the other Modicon products. They contain a computer that can control 2 axes.
|
This is the form for the I2T servo modules. You can see a slight difference on the base from the INPUT module with the RJ-45 receptacle. |
|
|
In the I2T servo modules, the serial port is an RJ-45 receptacle port shown in this image. INPUT and OUTPUT modules don't include this port. |
|
INPUT Base with Ethernet Communication Adapter
The Ethernet Communications Adapter holds the IP address for this base, and receives the Ethernet cable from a switch or a hub. Each bender is its own small Class C network with addresses like 192.168.0.201, 192.168.0.202, etc.
BACK of Modicon Momentum I/O Base
This is the back of the base with a channel for receiving a DIN rail.
Other Pages
- Back to CNC Bender page
- Back to CNC Bender General Information page
- Back to CNC Bender Technical Notes page
