Difference between revisions of "Modicon Momentum"
(→BACK of Modicon Momentum I/O Base) |
|||
| Line 1: | Line 1: | ||
| − | |||
| − | |||
__TOC__ | __TOC__ | ||
==About the Modicon Momemtum Package== | ==About the Modicon Momemtum Package== | ||
| + | <table> | ||
| + | <tr> | ||
| + | <td width=300> | ||
This the form of the modules that are installed to machines that use our CNC Bender software. The different modules come in a variety of functions - but the same packaging. For example, the image above shows an INPUT base with 32-points with an Ethernet Communications Adapter clipped on the top. | This the form of the modules that are installed to machines that use our CNC Bender software. The different modules come in a variety of functions - but the same packaging. For example, the image above shows an INPUT base with 32-points with an Ethernet Communications Adapter clipped on the top. | ||
| Line 11: | Line 12: | ||
They mount to [http://en.wikipedia.org/wiki/DIN_rail DIN] rails in electrical panels. | They mount to [http://en.wikipedia.org/wiki/DIN_rail DIN] rails in electrical panels. | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:tsxmomentum_ethernet_communications_adapter1.jpg|300px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
<br><br> | <br><br> | ||
Revision as of 12:41, 23 December 2009
Contents |
About the Modicon Momemtum Package
|
This the form of the modules that are installed to machines that use our CNC Bender software. The different modules come in a variety of functions - but the same packaging. For example, the image above shows an INPUT base with 32-points with an Ethernet Communications Adapter clipped on the top. See this data sheet (16 pages) for an overview of these modules. View the Modicon Momentum I/O Base User Guide (662 pages). They mount to DIN rails in electrical panels. |
|
I2T IFC220E Servo Modules
The I2T (Pronounced "I Square T") servo modules use the same package form as the other Modicon products. The base unit contains a computer that can control 2 axes.
|
This is the form for the I2T servo modules with an Ethernet Communications Adapter on the top. You can see a slight difference on the base from the INPUT module with the RJ-45 receptacle. |
|
|
In the I2T servo modules, the serial port is an RJ-45 receptacle port shown in this image. INPUT and OUTPUT modules don't include this port. |
|
INPUT Base with Ethernet Communication Adapter
The Ethernet Communications Adapter holds the IP address for this base, and receives the Ethernet cable from a switch or a hub. Each bender is its own small Class C network with addresses like 192.168.0.201, 192.168.0.202, etc.
BACK of Modicon Momentum I/O Base
This is the back of the base with a channel for receiving a DIN rail.
Other Pages
- Back to CNC Bender page
- Back to CNC Bender General Information page
- Back to CNC Bender Technical Notes page
