Difference between revisions of "CNC Bender v12-20100316"
From ATTWiki
| Line 35: | Line 35: | ||
<tr><td width=75>Value Type</td><td>The value is entered as a floating point percentage.</td></tr> | <tr><td width=75>Value Type</td><td>The value is entered as a floating point percentage.</td></tr> | ||
<tr><td>+ or -</td><td>The value can be positive or negative.</td></tr> | <tr><td>+ or -</td><td>The value can be positive or negative.</td></tr> | ||
| − | <tr><td>Negative Values</td><td>Negative values slow the calculated speed of the Feed axis.</td></tr> | + | <tr><td>Impact of Negative Values</td><td>Negative values slow the calculated speed of the Feed axis.</td></tr> |
<tr><td>Example +</td><td>A value of +100 would double the speed of the Feed axis during draw bending.</td></tr> | <tr><td>Example +</td><td>A value of +100 would double the speed of the Feed axis during draw bending.</td></tr> | ||
<tr><td>Example -</td><td>A value of -100 would set the speed at 0 for the Feed axis during draw bending.</td></tr> | <tr><td>Example -</td><td>A value of -100 would set the speed at 0 for the Feed axis during draw bending.</td></tr> | ||
Revision as of 12:59, 16 March 2010
|
|
|
Contents |
NEW - Feed Speed Percentage Adjustment for Feed Bend Mode
|
This new bend option allows you to fine-tune the calculated feed speed during Feed Bending.
|
|
||||||||||
|
For example "-10" means negative 10 percent. |
Speed calculated at 100% (see vel0) |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
