Difference between revisions of "CNC Bender v12-20100316"
From ATTWiki
| Line 36: | Line 36: | ||
</td> | </td> | ||
</tr> | </tr> | ||
| − | |||
<tr><td>Value Type:</td><td>The value is entered as a floating point percentage.</td></tr> | <tr><td>Value Type:</td><td>The value is entered as a floating point percentage.</td></tr> | ||
| Line 44: | Line 43: | ||
<tr><td>Example -:</td><td>A value of -100 would set the speed at 0 for the Feed axis during draw bending.</td></tr> | <tr><td>Example -:</td><td>A value of -100 would set the speed at 0 for the Feed axis during draw bending.</td></tr> | ||
| − | < | + | <tr><td></td><td></td></tr> |
<tr valign=top> | <tr valign=top> | ||
Revision as of 13:04, 16 March 2010
|
|
|
Contents |
NEW - Feed Speed Percentage Adjustment for Feed Bend Mode
|
This new bend option allows you to fine-tune the calculated feed speed during Feed Bending.
|
|
| Value Type: | The value is entered as a floating point percentage. |
| + or -: | The value can be positive or negative. |
| Impact of Negative Values: | Negative values slow the calculated speed of the Feed axis. |
| Example +: | A value of +100 would double the speed of the Feed axis during draw bending. |
| Example -: | A value of -100 would set the speed at 0 for the Feed axis during draw bending. |
|
The table at the right shows an example of a -10% change in the processlist: |
See vel0 calculated at 100%: |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
