Difference between revisions of "CNC Bender v12-20100407"
From ATTWiki
| Line 31: | Line 31: | ||
<td width=300> | <td width=300> | ||
When a Windows XP operator station is running for 24.85 days, then it could cause an out of range error in timer in CNC Processor. This has been resolved.<br><br> | When a Windows XP operator station is running for 24.85 days, then it could cause an out of range error in timer in CNC Processor. This has been resolved.<br><br> | ||
| + | </td> | ||
| + | <td> | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | </td> | ||
| + | |||
| + | <td> | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | </table> | ||
| + | |||
| + | |||
| + | <br><br> | ||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] REPAIRED - Resource Memory Leaks Repeared=== | ||
| + | <table> | ||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | Minor user interface memory leaks were repaired.<br><br> | ||
</td> | </td> | ||
<td> | <td> | ||
Revision as of 03:44, 9 April 2010
|
|
|
Contents |
REPAIRED - Extended Windows Uptime Timer Issues
|
When a Windows XP operator station is running for 24.85 days, then it could cause an out of range error in timer in CNC Processor. This has been resolved. |
|
REPAIRED - Resource Memory Leaks Repeared
|
Minor user interface memory leaks were repaired. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
