Difference between revisions of "CNC Bender v12-20100611"

From ATTWiki
Jump to: navigation, search
(→‎25px REPAIRED - Direct Axes Jog Buttons Stick Down)
(→‎25px REPAIRED - Automatic Feed Adjustment During Part Load)
Line 63: Line 63:
  
  
−
===[[image:Check.jpg|25px]] REPAIRED - Automatic Feed Adjustment During Part Load===
 
−
<table>
 
−
<tr valign=top>
 
−
<td width=300>
 
−
The automatic feed adjustment feature works by advising operators that incoming part data was from another bender with a different bed length.  We discovered that two of the Tool page options were not being changed properly.  This is corrected.</td>
 
−
<td>
 
−
</td>
 
−
</tr>
 
  
−
<tr valign=top>
 
−
<td width=300>
 
−
</td>
 
−
<td>
 
−
</td>
 
−
</tr>
 
−
 
−
</table>
 
  
 
=Other Pages=
 
=Other Pages=

Revision as of 14:09, 14 June 2010

Cncv12procontrol withteachmode.jpg


V12mainmenu.jpg

Contents


Check.jpg NEW - CNC Bender Direct-Axis Jog with Joystick or Pendant

CNC Bender can now respond to a joystick or pendant buttons when direct-axis jogging.

Euchnerpendant.jpg

Joystick.jpg

Check.jpg NEW- Direct Axis Jog from INPUT Options

The low level general options list contains three new options: ENABLE, JOG+ Input Name, JOG- Input Name. If this feature is enabled, then the input names are used to lookup the input points in the CIO dictionary.




Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v12-20100611&oldid=14191"