Difference between revisions of "CNC Bender v12-20100820"
From ATTWiki
| Line 47: | Line 47: | ||
<td> | <td> | ||
[[image:cncbender_bigmessages.jpg|350px]]<br> | [[image:cncbender_bigmessages.jpg|350px]]<br> | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | </td> | ||
| + | <td> | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] NEW - Press ENABLE to Jog === | ||
| + | <table> | ||
| + | <tr valign=top> | ||
| + | <td width=200> | ||
| + | Erin Industries controls require that the operator press the ENABLE button to Jog.<br><br> | ||
| + | |||
| + | CNC Bender can be set in Low Level to require an ENABLE button for all jogging. If the ENABLE button is not pressed when the joy stick is moved, then the "Press ENABLE to Jog" message appears on the screen. | ||
| + | <br><br> | ||
| + | [[image:cncbender_enablebutton.jpg|300px]]<br> | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:cncbender_bigmessage_PressEnableToJog.jpg|350px]]<br> | ||
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 21:47, 20 August 2010
|
|
NEW - Servo Status Grid Now Always Visible on Main Screen
|
The status of up to 20 servo axes are now displayed at all times in a small grid on the main page. Whenever the states change, the grid cells color changes to either grey, green, or red. |
|
NEW - BIG Messages
|
For important events, CNC Bender now displays large messages for short periods of time. This lets operators clearly know what the control needs them to do next.
|
|
NEW - Press ENABLE to Jog
|
Erin Industries controls require that the operator press the ENABLE button to Jog. CNC Bender can be set in Low Level to require an ENABLE button for all jogging. If the ENABLE button is not pressed when the joy stick is moved, then the "Press ENABLE to Jog" message appears on the screen.
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
