Difference between revisions of "CNC Bender v12-20101021"
From ATTWiki
| Line 49: | Line 49: | ||
The keyboard features were completely locked out of previous user interfaces to prevent a problem with accidental motion in the MANUAL page. This was too drastic and restrictive for operators that wanted to use the keyboard. | The keyboard features were completely locked out of previous user interfaces to prevent a problem with accidental motion in the MANUAL page. This was too drastic and restrictive for operators that wanted to use the keyboard. | ||
<br><br> | <br><br> | ||
| − | Now the keyboard works in every part of the user interface except | + | Now the keyboard works in every part of the user interface except with the manual buttons that can cause motion. Manual buttons will not receive any keyboard input. |
</td> | </td> | ||
<td> | <td> | ||
| − | [[image:keyboard.jpg| | + | [[image:keyboard.jpg|250px]] |
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 20:44, 22 October 2010
|
|
Contents |
NEW - Added Input Timer in PreEnable
|
Schneider Lexium drives require a pulse to switch from READY to RUN mode. This feature was added to allow for pulsing Lexium drives a specific amount of time before the axes were enabled. |
|
FIXED - Early Mandrel Extra On Last Bend
|
For benders with motion controlled PDA - the early mandrel extract now works. |
|
CHANGED- KEYBOARD HANDLING
|
The keyboard features were completely locked out of previous user interfaces to prevent a problem with accidental motion in the MANUAL page. This was too drastic and restrictive for operators that wanted to use the keyboard.
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
