Difference between revisions of "CNC Bender v12-20101116"
From ATTWiki
| Line 19: | Line 19: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=200> | <td width=200> | ||
| − | The absolute pre-rotate command is highly optimized to rotate the spindle when the feed carriage is moving away from the part during the last bend. | + | The absolute pre-rotate command is highly optimized to rotate the spindle when the feed carriage is moving away from the part during the last bend.<br> |
| + | <br> | ||
| + | We have added this programmed delay to allow the operator to ensure that the chuck is off the part before rotating. (This is especially important for non-cylindrical tubes.) | ||
<br><br> | <br><br> | ||
The new command is found in Prebending options. | The new command is found in Prebending options. | ||
Revision as of 17:13, 16 November 2010
|
|
Contents |
NEW - Absolute Pre-Rotate Delay
|
The absolute pre-rotate command is highly optimized to rotate the spindle when the feed carriage is moving away from the part during the last bend. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
