Difference between revisions of "VTube-LASER v1.59"
From ATTWiki
| Line 70: | Line 70: | ||
This version removes these radio buttons and uses an large button with either an M or an I that toggles the state.</td> | This version removes these radio buttons and uses an large button with either an M or an I that toggles the state.</td> | ||
<td> | <td> | ||
| − | Old:<br> | + | Old: |
| + | <br> | ||
[[image:vtube_laser_linear_units.jpg]] | [[image:vtube_laser_linear_units.jpg]] | ||
| − | New Millimeter:<br> | + | <br> |
| + | New Millimeter: | ||
| + | <br> | ||
[[image:vtube_laser_linear_units_button_millimeter.jpg]] | [[image:vtube_laser_linear_units_button_millimeter.jpg]] | ||
| − | New Inch:<br> | + | <br> |
| + | New Inch: | ||
| + | <br> | ||
[[image:vtube_laser_linear_units_button_inch.jpg]] | [[image:vtube_laser_linear_units_button_inch.jpg]] | ||
| + | <br> | ||
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 13:53, 10 February 2011
|
Revision 1.59Back to VTube-LASER |
|
NEW: Help Reference for LASER Mode
|
Now VTube-LASER has its own help reference. |
|
REPAIR: Mix ball probe and laser measurement
|
Using ball probe measurements on the end scans and and laser measurements in the cylinder straights now offsets the ball radius point properly in every case. |
|
ENHANCEMENT- Part Name is Used as Filename When Part Name Changes
|
In previous versions, the part name was used as the filename only if the previous filename was empty.
|
|
ENHANCED- Linear Units Now Set By Single Large Button
|
In previous versions, the linear units radio buttons were not reliable in setting the proper state. Plus they were too small to easily press. |
Old:
|
REPAIR- Laser Active Initialization
|
In previous versions, VTube required the operator to enter Measure Setup at least one time when coming into Laser Mode in order to setup the Laser active mode. |
|
Changes to VTube-STEP
|
Issues with this version fixed in next version
|
Other Pages
- Back to VTube-LASER
