Difference between revisions of "CNC Bender v12-20110212"

From ATTWiki
Jump to: navigation, search
(→‎25px ENHANCEMENTS - New Message in Splash)
(→‎25px Other Changes)
Line 64: Line 64:
  
 
<td>
 
<td>
−
[[image:cncbender_splash_nooptionvisibilityfile.jpg|400px]]
 
 
</td>
 
</td>
  

Revision as of 18:37, 14 February 2011

v12-20110212

Cncv12procontrol withteachmode.jpg


Check.jpg ENHANCEMENTS - New Option Visibility Control for OEMs

  • OEMs now have option list control that is protected by encryption. Any list option can be switched off by the OEM during machine setup.

  • Push Bend Allow and PDA-RVG Allow no longer switch on automatically in the general dynamic options list if a license for either option is found in the hardware key. Only the setup technician can enable or disable these values in the Low Level menu of CNC Bender ProControl.



Cncbender dynamicoptionlistcontrol.jpg



Check.jpg ENHANCEMENTS - New Message in Splash

  • If the CNC Bender Options Visibility configuration file is not present, then CNC Bender will not load.

  • The splash screen will show this message:

Cncbender splash nooptionvisibilityfile.jpg




Check.jpg Other Changes

  • The CNCBenderDOD.cfg filename is changes to DynamicOptionVisibility.cfg in order to better reflect the purpose of the file.



  • If this file does not exist, then CNC Bender will not run.



Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v12-20110212&oldid=15986"